Invacare Ranger IISTANDARD Wheelchair User Manual


 
64
This Procedure Includes the Following:
Assembling Ranger II MWD
When to Charge Batteries
Charging Batteries
Replacing Batteries
Installing/Removing Battery Boxes
Battery Tray
Replacing Wiring Harness
Stabilizer Identification
Adjusting Stabilizer Springs
Adjusting Stabilizer for User Preference
Replacing Stabilizer Cylinders
Replacing Stabilizer Wheels
Replacing Stabilizer Cylinder Springs
Repositioning Motors
Replacing Clutch Handles - R2
BASIC
AND R2
250 SERIES
Replacing Motor/Gearbox - R2
BASIC
AND R2
250 SERIES
Replacing Motor/Gearbox - R2
STANDARD
FIGURE 1 - ASSEMBLING RANGER II MWD - INTEGRATED SLING SEATS
Install the battery tray and batteries. Refer to INSTALL-
ING/REMOVING BATTERY TRAY and INSTALLING/
REMOVING BATTERY BOXES in this procedure of the
manual.
Install the electronics. Refer to REPOSITIONING MKIV
JOYSTICK in PROCEDURE 7 of this manual.
Install the footrests/legrests. Refer to
INSTALLING/RE-
MOVING FOOTRESTS or INSTALLING ELEVATING
LEGRESTS in PROCEDURE 3 of the owner's manual,
part number 1080722.
Adjust the stabilizers. Refer to
ADJUSTING STABILIZ-
ERS in this procedure of the manual.
WARNING
After ANY adjustments, repair or service and BE-
FORE use, make sure that all attaching hardware
is tightened securely - otherwise injury or dam-
age may result.
ASSEMBLING RANGER II MWD
WARNING
The weight of the wheelchair without the user and
batteries is still between 100 and 116 lbs. Use
proper lifting techniques (lift with your legs) to
avoid injury. Extreme caution is advised when it is
necessary to move an UNOCCUPIED power
wheelchair. Invacare recommends using two (2)
assistants and making thorough preparations.
Make sure to use ONLY secure, non-detachable
parts for hand-hold supports.
Keep hands and fingers clear of moving parts to
avoid injury.
Unfolding/Folding Integrated Sling Seats
(FIGURE 1)
UNFOLDING.
1. Push down on the seat rails until the seat rails are
positioned in the seat guides.
2. Assemble the wheelchair. Refer to FIGURE 1.
3. If necessary, install the shrouds. Refer to
REMOV-
ING/INSTALLING SHROUDS in PROCEDURE 10
of this manual.
Seat Rails
Seat Guides
PROCEDURE 14 MWD WHEELCHAIRS
M
W
D
W
H
E
E
L
C
H
A
I
R
S