Support User Manuals

Invacare EX2 Wheelchair User Manual

Open as PDF

of 40

SECTION 6—SEAT AND BACK

Part No. 1110546 29 Tracer

®

EX2

Fixed Frame

NOTE:Forthisprocedure,refertoFIGURE 6.4.

Removing Lower Mounting Hardware

1. Removetheexistingbackandseatupholsteryfromthewheelchair.RefertoReplacingBackUpholsteryonpage 26and

ReplacingSeatUpholstery

onpage 26.

NOTE:Ifadjustingtheseatwidthofthewheelchair,backandseatupholsteryaswellasthecrossbracesMUSTbereplaced.

2. Removethefourscrewsandlocknutsthatsecuretheinserttubetothelowerwheelchairframe.

3. Removetheinsertsfromtherearofthewheelchair.

4. Removethehexscrew

andlocknutthatsecurethetwoexistingcrossbracestogether.

Removing Upper Mounting Hardware

1. Whilepushingdownontherearseatguide,pullupthefrontseatguideuntilthefrontseatguidereleasesfromthe

wheelchairframe.

2. Pullthecrossbraceawayfromtherearseatguide.

3. RepeatSTEPS1‐2foroppositecrossbrace.

4. ReverseSTEPS1‐3toassembletheuppermountinghardware.

5. ReverseSTEPS1

‐4inRemovingLowerMountingHardwareonpage 29.

FIGURE 6.4 Adjusting the Seat Width - Fixed Frame

DETAIL “B” -

REMOVING UPPER

MOUNTING

HARDWARE

DETAIL “A” - REMOVING LOWER

MOUNTING HARDWARE

Rear Seat Guide

Crossbrace

Front Seat Guide

Crossbrace

Insert Tube

Wheelchair Frame

Locknut

Screw

Hex Screw

previous next