Support User Manuals

Invacare EX2 Wheelchair User Manual

Open as PDF

of 40

SECTION 4—FRONT RIGGINGS

Part No. 1110546 21 Tracer® EX2

Fixed Frame

NOTE:Forthisprocedure,refertoFIGURE 4.4

1. Removeimpactguardsand/orcalfstrap,ifnecessary.

2. Loosen,butdonotremovetheboltandlocknutthat

securethelowerfootrestassemblytotheupperfootrest

support.

3. Repositionthelowerfootrestassemblytothedesired

height.

4. Securelytightentheboltandlocknut.

5. Repeatthisprocedure

fortheotherfootrest,if

necessary.

6. Replaceimpactguardsand/orcalfstrap,ifnecessary.

FIGURE 4.4 Fixed Frame

Raising/Lowering Elevating Legrest Assembly

ƽ WARNING

Ensure hands and fingers are clear of elevating legrest mechanism before pushing release lever

to lower the elevating legrest. Otherwise injury may occur due to pinch points.

The wheelchair user’s leg MUST be supported by an assistant before attempting to lower

legrest.

NOTE:Forthisprocedure,refertoFIGURE 4.5.

1. Toraisetheelevatinglegrest,theassistantshouldholdthesupporttubeandraisetheelevatinglegrestuntilthedesired

heightisobtained.

2. Tolowertheelevatinglegrest,performthefollowing:

A. Supportuserlegwithonehand.

B. Pushreleaseleverdownwardwithotherhand.

C. Gently,loweruserlegdownandrestagainstthelegrest.

FIGURE 4.5 Raising/Lowering Elevating Legrest Assembly

Bolt and

Locknut

Wheelchair Frame

Footplate

Assembly

Release Lever

Support

Tube

previous next