Support User Manuals

Invacare EX2 Wheelchair User Manual

Open as PDF

of 40

SECTION 5—ARMS

Part No. 1110546 25 Tracer® EX2

Removing/Installing Armrests

ƽ WARNING

Make sure the armrest release lever is in the locked position before using the wheelchair.

NOTE:Forthisprocedure,refertoFIGURE 5.2onpage25.

Removing Armrest

1. Pushdownonarmresttoensureitisfullyseatedinfrontandrearsockets.

NOTE:STEP1preventsthereleasebuttonsfromhanginguponthesocketsduringremoval.

2. Pressinthearmrestreleasebuttonat thefrontandrearofthearmrest.

3. Whilepressinginthearmrestreleasebuttons,remove

thearmrestfromthearmsocketsbypullingstraightup.

Installing Armrest

1. Positionthearmrestjustabovethefrontandreararmsockets.

2. Pusharmdownevenlyatthefrontandrearuntilthefrontandreararmrestreleasebuttosnsnapintothearmsockets.

3. Ensurearmrestislockedsecurelyinthearmsocketsbygentlyliftingup.Ifnotlocked,repeatSTEPS1

‐3.

FIGURE 5.2 Removing/Installing Armrests

Armrest Release

Button

Armrest

Rear Arm

Socket

Front Arm

Socket

Armrest Release

Button

previous next