Filter
Top Products
16
Mounting Hole Position for Flat Screws -
Wheelchairs Built AFTER 09/05/00
Rear Wheel Hole-A Hole-B Hole-C Hole-D
Size
20 X X
22 X X
24 X X
Mounting
Holes
Transmission
Support
Bracket
This procedure includes the following:
Installing CLD on Existing Wheelchair
Replacing the CLD Wheel Lock
Installing/Removing CLD Wheel Lock
Adjusting Wheel Lock Assembly Position
Adjusting Wheel Lock Engagement Position
WARNING
After ANY adjustments, repair or service and BE-
FORE use, make sure all attaching hardware is
tightened securely - otherwise injury or damage
may result.
W
H
E
E
L
L
O
C
K
PROCEDURE 5 WHEEL LOCK
INSTALLING CLD ON EXISTING
WHEELCHAIR
1. Adjusting the wheel lock assembly position. Refer to
ADJUSTING WHEEL LOCK ASSEMBLY POSI-
TION in this procedure of the manual.
2. Adjust the wheel lock engagement position. Refer
to
ADJUSTING WHEEL LOCK ENGAGEMENT
POSITION in this procedure of the manual.
REPLACING THE CLD WHEEL LOCK
1. Remove the EXISTING CLD wheel lock. Refer to
INSTALLING/REMOVING THE CLD WHEEL LOCK
in this procedure of the manual.
2. Install the NEW CLD wheel lock. Refer to
INSTALL-
ING/REMOVING THE CLD WHEEL LOCK in this
procedure of the manual.
INSTALLING/REMOVING THE CLD
WHEEL LOCK (FIGURE 1)
Installing
1. Secure the wheel lock to the transmission support
bracket with the two (2) flat screws. Securely tighten.
Removing
1. Remove the two (2) flat screws securing the wheel
lock to the transmission support bracket.
2. Remove the wheel lock from the transmission sup-
port bracket.
ADJUSTING WHEEL LOCK
ASSEMBLY POSITION (FIGURE 2)
NOTE: If wheels are pneumatic, before adjusting the
wheel lock, ensure that the tires are inflated to the rec-
ommended psi located on the side wall of the tire.
1. Refer to the chart on this page to determine the mount-
ing position of the two (2) flat screws securing the wheel
lock adjustment rod to the wheel lock support bracket.
2. Secure wheel lock adjustment rod to the wheel lock
support bracket with the two (2) flat screws. Tighten
securely.
FRONT VIEW OF TRANSMISSION SUPPORT
BRACKET
Mounting
Holes
Wheel
Lock
Support
Bracket
ABC
Wheelchairs Built BEFORE 09/05/00
Wheelchairs Built AFTER 09/05/00
Mounting Hole Position for Flat Screws -
Wheelchairs Built BEFORE 09/05/00
Rear Wheel Hole-A Hole-B Hole-C
Size
20 X X
22 X X
24 X X
FIGURE 1 - INSTALLING/REMOVING THE CLD
WHEEL LOCK
Wheel
Lock
Transmission
Bracket
Flat Screws