Filter
Top Products
Wheelchair Operation
5.6 Removing/Installing the Seat Assembly
Removing
1. Disconnect the joystick. Refer to Disconnecting/Connecting the
Joysticks, page 35.
2. Fold down the seat back. Refer to 5.7 Using the Folding Back
Assembly, page 29.
3. Lift the seat lever A up to release the seat.
4. While holding the seat lever, lift the rear of the seat assembly
B to tilt the seat assembly up.
WARNING!
– DO NOT use armrests to lift seat, otherwise
injury or damage may occur. Use lifting locations
shown in illustration.
5. Pull seat upward towards the rear of the personal transporter
and remove the seat assembly from the seat post mounting pins.
Installing
1. Place the seat mounting bracket C onto the seat mounting pins
and slide the seat assembly forward until the front seat mounting
pin D engages the front slot in the seat mounting bracket.
2. Lower the rear of the seat until the rear seat mounting pin E
clicks and locks into the seat mount bracket.
3. Pull the seat assembly up to ensure that it is locked in place.
4. Unfold the back. Refer to 5.7 Using the Folding Back Assembly,
page 29.
5. Connect the joystick. Refer to Disconnecting/Connecting the
Joysticks, page 35.
5.7 Using the Folding Back Assembly
• To fold the back assembly down, perform the following:
1. Hold both sides of the back and pull up.
2. Push the back forward towards the seat, while maintaining
upward tension on back.
• To unfold the back assembly, perform the following:
1171794-B 29