Support User Manuals

Invacare 1163197 Wheelchair User Manual

Open as PDF

of 52

SECTION 7—REAR WHEELS

Insignia

™

32 Part No. 1163197

5. Reinstallrearwheelontothewheelchair.RefertoRemoving/InstallingRearWheelsonpage 30.

FIGURE 7.2 Adjusting Quick-Release Axle

Replacing Rear Wheel Handrim

NOTE:Forthisprocedure,refertoFIGURE 7.3.

1. Removetherearwheelfromthewheelchair.Referto

Removing/Install ingRearWheels

onpage 30.

2. Removethemountingscrewsthatsecurethehandrim

totherearwheel.

3. Removetheexistinghandrim.

4. Installthenewhandrimbyreversingthepreceding

steps.

FIGURE 7.3 Replacing Rear Wheel Handrim

ƽ WARNING

Make sure detent pin and detent balls of the quick-release axles are fully released before

operating the wheelchair.

5. Reinstallrearwheeltothewheelchair.RefertoRemoving/InstallingRearWheelsonpage 30.

6. Ifthedetentballsofthequick‐releaseaxles(ifapplicable)arenotprotrudingpastthe insideoftheaxlebushingorthere

istoomuchmovementoftherearwheelassemblyinabackandforthposition,refertoAdjustingQuick‐ReleaseAxle



onpage 31.

7. RepeatSTEPS1‐6forthe opp ositerearwheelifnecessary.

Replacing/Repairing Rear Wheel Tire

ƽ WARNING

Replacement of rear wheel tire or tube MUST be performed by a qualified technician.

Quick-Release Axle

Detent Balls

Mounting Screw

Rear Wheel

Handrim

previous next