Support User Manuals

Invacare 1163197 Wheelchair User Manual

Open as PDF

of 52

SECTION 4—FRONT RIGGINGS

Insignia

™

20 Part No. 1163197

SECTION 4—FRONT RIGGINGS

ƽ WARNING

After any adjustments, repair or service and before use, make sure all attaching hardware is

tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings Assembly

NOTE:Forthisprocedure,refertoFIGURE 4.1.

Installing

1. Turnthefrontriggingassemblytotheside(openfrontriggingisperpendiculartowheelchair).

2. Installthehingeplatesonthefrontriggingassemblyontothehingepinsonthewheelchairframe.

3. Pushthefrontriggingassemblytowardstheinsideofthewheelchairuntilitlocksintoplace.An“audible”clickwill

be

heardwhenlockedinplace.

NOTE:Thefootplatewillbeontheinsideofthewheelchairwhenlockedinplace.

Removing

1. Pushthefrontriggingreleaseleverinward.

2. Rotateswingawayfrontriggingassemblyoutward.

3. Lifttheswingawayfrontriggingassemblyoffthehingepins.

FIGURE 4.1 Installing/Removing Front Riggings Assembly

Front Rigging

Assembly

Hinge Plates/

Hinge Pins

DETAIL “A”

DETAIL “B”

Rotate inward to use.

Rotate outward to remove

Front

Rigging

Release

Lever

Hinge Plates/

Hinge Pins

previous next