Filter
Top Products
30 Genie Z-80/60 Part No. 82258
Operator's Manual First Edition · Third Printing
TRANSPORT AND LIFTING INSTRUCTIONS
Observe and Obey:
Only qualified riggers should rig and lift the
machine.
Be sure the crane capacity, loading surfaces
and straps or lines are sufficient to withstand
the machine weight. See the serial plate for the
machine weight.
Lifting Instructions
Fully lower and retract both the primary and
secondary booms. Remove all loose items on the
machine.
Rotate the turntable 90 degrees.
Determine the center of gravity of your machine
using the measurements on the pictures on this
page.
Attach the rigging only to the designated lifting
points on the machine.
Attach the rigging to the 2 chassis lifting points
farthest from the turntable lifting point.
Adjust the rigging to prevent damage to the
machine and to keep the machine level.
Chassis
Lifting
Points (2)
Turntable
Lifting
Point
39.61 in / 1 m
34.18 in
86.8 cm
56 in
1.42 m