Filter
Top Products
20 Genie Z-80/60 Part No. 82258
Operator's Manual First Edition · Third Printing
FUNCTION TESTS
Test Limited Drive Speed
63 Press down the foot switch.
64 Raise the primary boom to 10° above horizontal.
65 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not exceed
1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40
seconds.
66 Lower the primary boom to the stowed position.
67 Extend the primary boom 4 feet / 1.2 m.
68 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40
seconds.
69 Retract the primary boom to the stowed position.
70 Raise the secondary boom to 10° above
horizontal.
71 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 foot / 30 cm per second.
Note: The machine will travel 40 feet / 12 m in 40
seconds.
72 Lower the secondary boom to the stowed
position.
If the drive speed with the primary or secondary
boom raised or the primary boom extended
exceeds 1 foot / 30 cm per second, immediately
tag and remove the machine from service.
Test Auxiliary Controls
73 Push in the red Emergency Stop button to the
off position to shut off the engine.
74 Pull out the red Emergency Stop button to
the on position.
75 Press down the foot switch.
76 Simultaneously press and hold the auxiliary
power button and activate each function control
handle, toggle switch or button.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate.