196
Chapter 11 Novell LineJet Print Server Configuration (10/100Base-T)
Novell LineJet Print Server Configuration (10/100Base-T)
There are no mandatory Novell settings needed before the print server can be
detected on the network. However, there can be some mandatory settings
needed before a Novell print queue can be serviced by the LineJet Print
Server. These mandatory settings are covered separately for Netware 3.x and
4.x under the Host Configuration heading.
The print server setup in a Novell environment is much simpler than that
required in a TCP/IP one. No addresses, masks, or router entries are
necessary, and, in most cases, the LineJet Print Server can simply be
connected to the network, turned on, and then configured for printing from a
Novell station through PCONSOLE or Netware Administrator. See Figure 16
for an example of a Novell network which shows the use of file servers and
how they relate to the print server.
There are, however, some optional parameters you may wish to change such
as the preferred file server(s), print server password, polling time, frame type,
print server name, NDS context, and NDS preferred tree. The following
sections describe these optional parameters.
Figure 16. Novell Integration
Bridge/Router
NetWare 4.1
File Server
NetWare
Workstation
NetWare
Workstation
NetWare
Workstation
NetWare
Workstation
NetWare 4.1
File Server
