A SERVICE OF

logo

Procedures
ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07 3-25
Configuring the Aastra CNX
10
(cont’d)
T1/E1 attributes continued.
11 Click to save the configuration to the Aastra CNX and to the CompactFlash card.
Step Action
Attribute Default Valid Values/Description
Line Buildout For T1 Framing:
0 to 110
ft.(DSX-1)
For E1 Framing:
120 Ohms
For T1 Framing:
Short-haul values:
0 to 110 ft.(DSX-1)
110 to 220 ft. (DSX-1)
220 to 330 ft. (DSX-1)
330 to 440 ft. (DSX-1)
440 to 550 ft. (DSX-1)
550 to 660 ft. (DSX-1)
Long-haul values:
0 dB (long haul)
-7.5 dB (long haul)
-15 dB (long haul)
-22.5 dB (long haul)
For E1 Framing:
120 Ohms
CRC
Note: Applies to E1
Framing only.
ENABLE ENABLE
DISABLE
Overlap
Note: Applies to E1
Framing only.
DISABLE ENABLE
DISABLE
Number of digits
Note: Applies to T1
RBS or E1 PRI only.
0 0 to 10
Description: Sets the number of digits to wait before
starting the PIN collection announcement. This field is
enabled only if the Switch Type is set to an RBS value
for T1 or PRI ETSI for E1.
Port 1 ENABLE ENABLE
DISABLE
Port 2 DISABLE ENABLE
DISABLE
Port 3 DISABLE ENABLE
DISABLE
Port 4 DISABLE ENABLE
DISABLE