Filter
Top Products
Issue 7 34
The Penny and Giles Pilot + control pod
Power supply
Ensure the power lead is connected
correctly into its socket on the rear of
the control pod (Fig. 33).
The immobiliser plug
When this is activated the chair will not
function, other than the hazard warning
light system. This may be useful if you
wish to leave your wheelchair
unattended (Fig. 33).
To activate the immobiliser
1. Switch the chair on via the On/Off
button (Fig. 34).
2. Insert the immobiliser plug into the
charger/programmer socket located
on the front of the control pod.
3. Remove the plug after 1 - 2 seconds.
4. Your chair should now be
immobilised.
To de-activate the immobiliser
1. Switch the chair on via the On/Off
button (Fig. 34).
2. Insert the immobiliser plug into the
charger/programmer socket located
on the front of the control pod.
3. Remove the plug after 1 - 2 seconds.
4. Your chair should now be ready to
use.
Fig. 33
Fig. 34
On/Off
button
Immobiliser
plug
Charger /
programmer
socket