Filter
Top Products
15 Issue 7
Preparing your wheelchair for use
Power
supply
Outer
cover
Power lead attachment
The power lead must also be plugged
into the socket as shown in Fig. 3.
WARNING
When unplugging the power lead
pull off by gripping the outer plastic
cover. Never pull the cable to
disconnect the plug.
Fig. 4
WARNING
To avoid injury to people around you please
be aware that the mirror protudes outside
the space envelope of the chair and could
cause injury to someone when driving past.
The mirror must be used on the 10KPH model
on UK roads.
Attaching the rear view mirror
1. Firstly set the Pilot Plus remote pod
arm into the desired position.
2. Place the metal clamp over the remote
arm, between the adjust bracket and
the rubber gaiter of the Pilot Plus swing-
away. The holes must be toward the
outside of the chair.
3. Place the mirror through the clamp
holes and then, using the locking
handle, begin to tighten the mirror in
position.
4. The mirror should stand vertically once
in position but can be subsequently
adjusted by slackening off the locking
handle, adjusting the mirror and then
re-tightening - See Fig. 4.
Always make sure that when using the
mirror that it is clean and unbroken so
that it does not impair your visibility.
Fig. 3