Filter
Top Products
9 Issue 7
Torque Settings
• A torque setting is the optimal
tightening for a particular fastener.
Use a torque wrench to secure
screws, nuts and bolts on this chair.
NOTE: Unless otherwise noted, use
a torque setting of 13.5Nm for all
fasteners.
Safety warnings and user tips
WARNING
Fasteners
• Many of the screws and bolts on
this chair are special high-strength
fasteners and may have special
coatings.
• Many nuts are of the Nyloc type.
Nylocs are single use fasteners and
must be replaced when removed.
They have a plastic insert to help
prevent loosening.
• Only use screws, bolts and nuts
provided by Sunrise.
1. Use of improper fasteners may
cause the chair to fail.
2. Over or under-tightened fasteners
may fail or cause damage to chair
parts.
3. If bolts or screws become loose,
tighten them as soon as you can.
Loose bolts or screws can cause
damage to other chair parts causing
them to fail.
WARNING
Speciality Controls
• Any specialist controls may have a
detrimental effect on stability. We
strongly recommend you apply
caution when negotiating slopes and
inclines.
WARNING
Be aware that latch drive can be
dangerous when using speciality
controls, please review the manual that
comes with your product for correct
use.
Washers and Spacers
• Note the position of washers and
spacers before disassembly.
• To avoid damage to the frame,
replace all washers and spacers
when you reassemble parts.
WARNING
User injury could occur when allowing
3rd party individuals to gain access to
the control system.
WARNING
Speciality control programming must
only be preformed by an Authorised
Sunrise Dealer.