Filter
Top Products
Issue 7 26
Power Articulating Legrest (ALR)
Fitting
Follow the instructions for the fitting and
removal of footrests as stated on page
20.
For the adjustment of the leg angle press
the mode button on the controller until
the chair option is illuminated. Move the
control lever to the left or right until the
footrest option is illuminated. Move the
joystick up or down to adjust the legrest
until in a suitable position.
In addition to the footrest fitting
instructions please ensure that the power
lead shown in fig is removed and refitted
along with the ALR - see fig 23 below.
WARNING
The use of an ALR can affect the stability
of the chair. Be especially careful when
riding up or down slopes.
With the leg in an elevated position it is
more likely that you could injure the leg
on obstacles in the environment. Make
sure that you are aware of your terrain
and be cautious when driving the chair
that your leg cannot impact on anything
around you.
Do not drive your chair too close to any
source of open flame. With your leg in
an elevated position you may not know
that the bottom of the footplate is getting
hot.
Do not hang items from the legrest, or
allow anyone to stand on the legrest with
it in the elevated or non-elevated position.
This could cause injury to them, to you or
could cause damage to the chair.
Make sure that the Power lead to the ALR’s
are free of all mechanisms to ensure that
it does not get trapped and can be pulled
out. If this happens the ALR will stop
operating and you may be trapped in the
chair
Inspect the legrest, footplate, calfpad and
heel loop regularly for signs of damage
or wear. Damage to the legrest could result
in the users leg being dropped and could
cause injury.
Cleaning Instructions
Footrest and calfpad - Clean with a damp
soapy cloth.
Paintwork - Clean with a damp, soapy
cloth.
Make sure that the legrest is completely
dry before using.
Fig. 23