Filter
Top Products
26
The Alarms
The VPAP III ST-A unit is fitted with alarms to alert you to changes that will affect
your treatment.
Alarm Mute Key
You can mute an alarm by pressing the Alarm Mute key once. If the problem is
still present, the alarm will sound again after two minutes. An alarm LED will
remain lit for as long as the problem is present.
Testing the Alarm
To test the alarm, hold down the Alarm Mute key for three seconds. On release
of the Alarm Mute key, the alarm should sound and the LED should flash for 10
seconds and then stop. ResMed recommends testing the alarm each week.
All menus remain available during an alarm. Treatment screens cannot be viewed
during an alarm condition.
Alarms Troubleshooting
The most common reason for an alarm to sound is because the system has not
been properly assembled. Check that the air tubing has been properly attached
to the flow generator and mask (and humidifier if used).
When an alarm has been activated, the bottom line of the LCD screen will display
either alarm information or recommended instructions for you or your clinician.
Note: The alarm actions listed below are based on having the appropriate
alarm settings for your therapy. When an alarm is activated, confirm the
alarm settings with your clinician.
!
CAUTION
In the event of power failure or machine malfunction, remove the mask.
Alarm LEDs
Alarm Mute key
LCD screen