Filter
Top Products
ENGLISH
If you are unable to resolve any leaks
you may need an alternative pillow
sleeve size.
7 Take time to adjust the following to
achieve a secure and comfortable fit:
• headgear straps
• angle of the pillow sleeve assembly
• position of the short tube assembly.
REMOVING THE MIRAGE SWIFT
To remove the MIRAGE SWIFT, pull the
pillow sleeve assembly away from your
nose and lift the headgear off your head.
You do not need to loosen the headgear
straps.
DISASSEMBLING FOR
CLEANING
See section C on the illustrations sheet.
Before disassembling the M
IRAGE SWIFT,
disconnect the flow generator tubing. To
do this, hold the swivel and pull it away
from the flow generator tubing.
CAUTION
Do not pull on the short tube or the flow
generator tubing as they may get
damaged.
• To disassemble the MIRAGE SWIFT for
daily cleaning, follow steps 1–3.
• To disassemble the MIRAGE SWIFT for
weekly cleaning, follow steps 1–5.
1 Detach the short tube assembly. To do
this, hold the elbow and pull it away
from the seal ring (C-1).
Note: The short tube assembly cannot be
taken apart.
2 Remove the cap by pulling it away from
the seal ring (C-2).
3 Detach the pillow sleeve assembly.
Simply pull the ends of the frame away
from the headgear rings (C-3).
4 Disassemble the pillow sleeve assembly.
To do this, slide off the clip (C-4a) and
then peel the pillow sleeve off the frame
(C-4b).
5 The seal rings do not need to be
removed from the headgear (C-5).
CLEANING THE MIRAGE SWIFT
IN THE HOME
DAILY
Wash the pillow sleeve assembly, short
tube assembly and cap with warm, soapy
water. Use pure soap (an example of pure
soap is Dove®soap, unscented; made by
Unilever). Rinse well and allow to air dry
out of direct sunlight.
WEEKLY
Note: The headgear may be washed without
being taken apart.
Hand wash the headgear, tube retainer and
components in warm, soapy water. Use
pure soap. Rinse the components well and
allow them to air dry out of direct sunlight.
. CAUTIONS
• Do not use solutions containing
bleach, chlorine, alcohol, aromatics,
moisturisers, antibacterial agents, or
scented oils to clean any part of the
system or air tubing. These solutions
may cause damage and reduce the life
of the product.
• Do not expose any part of the system
or tubing to direct sunlight as it may
deteriorate.
60872r4.book Page 3 Friday, November 4, 2005 9:31 AM