Filter
Top Products
19
Figure 3-13. Removing the PC Board from the Case
When re-installing the printed circuit board:
1. Hold the case (with the two mounting holes facing upwards
and to the right side of the case) in the left hand.
2. Hold the printed circuit board with the components showing
(soldered side down) in the right hand.
3. Slip the component board into the case and slide in as far
as it will go. You will also have to release the tab at the rear
on the other side of the case (turn case over) to allow the
board to fit all the way inside the case.
4. Go through steps 3 thru 5 in Section 3.3 in order to
re-install the backplate and screws, and also install the lens.
PC BOARD
PULL TAB HERE
PUSH HERE
P1 P2 P3
123 123
3412