Filter
Top Products
Chapter 10 Off-premise Message Notification 79
CallPilot Reference Guide
4 Press PAGER
or ‹ to select a pager number destination.
5 Enter the destination pager number and press OK
or £.
6 Press OK
or £ to accept the destination pager number represented
by <x>
or
press ADD
or ¤ to add special characters and use your dialpad or
follow the voice prompts to add characters.
After you add special characters, press OK
or £.
7 Press NEXT
or £ to accept the default pager message represented
by <xxxx>. The default pager message that CallPilot sends is the
CallPilot extension. This is the sequence of digits that is sent after
the pager service is dialed, to notify you of who is paging you
or
press CHNG
or ⁄ to change the pager message.
The combined limit is 30 characters for the pager phone number
and the pager message.
8 Press YES
or ⁄ if you want to set up another destination number
or
press NO
or £ if you do not want to set up another destination
number.
9 Press OK
or £ to be notified when you receive a new message
or
press CHNG
or ⁄ to change the message type to be notified only
when you receive an urgent message.
10 Press ® to end the session.
Destination:
PHONE EXT PAGER
Pager:
RETRY OK
<x>
ADD OK
Show:<xxxx>
CHNG NEXT
More dest?
YES NO
Msg type: new
CHNG OK
Msg notify
ADMIN SELECT