Filter
Top Products
84
UNLOCK Function
1. Use the power button to switch the control system on. The speed indicator will be rippling up and
down.
2. Move the joystick forward until the joystick beeps, then move the joystick backward until the
control system beeps.
3. Release the joystick, the control system will beep. The control system is now unlocked.
Adjusting Driving Speed
There are five pre-set speeds already programmed into the VSI control. To change speed, press the
Speed Decrease button to go slower or the Speed Increase button to go faster. The current speed is
indicated in the speed profile display.
Actuator Adjustment
To adjust the seat angle of your Powerchair press the actuator mode button once. The LED indicator
will illuminate, move your joystick forward or backward to adjust seat angle. Once the desired seat
angle has been achieved press the seat function button once to return to drive mode.
Battery Gauge
The battery gauge is used to indicate power and can also display the controller status shown in the
table. It displays battery charge, fault and status information from the VSI controller. If the battery
gauge shows RED, YELLOW and GREEN, the batteries are charged. If the battery gauges show just
RED and YELLOW, then you should charge the batteries as soon as you can. If the battery gauge
shows just RED, either steady or flashing slowly, then you should charge the batteries immediately.