Filter
Top Products
47
7.4 Installing / Removing or Adjusting Headrest (if fitted)
CAUTION:
•
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result..
Installing
1. Ensure set screws are not protruding into headrest
support tube.
2. Insert headrest assembly into headrest support tube.
3. Tighten the set screws using a hex wrench.
Removal
1. Loosen the set screws using a hex wrench.
2. Remove headrest assembly from headrest support
tube.
Adjusting
1. Loosen the headrest nuts with a spanner.
2. Loosen the hand lever by turning anti-clockwise.
3. Adjust to desired position
4. Re-tighten nuts and hand lever.
Headrest
Support Tube
Set Screws
Nuts
Hand Lever
Lateral Adjustment
Screws