45
7.2 Adjusting Backboard Position
WARNING
•
This adjustment should only be performed when the wheelchair is unoccupied.
•
Take care not to damage any accessories fitted to the backrest.
The backboard can be adjusted both in height and width (see section 8 Seating). This can be useful if
another type of back cushion is to be fitted.
1. Remove the four fixing screws using a cross point screwdriver.
2. Reposition the backboard.
3. Replace and tighten the four fixing screws.
NOTE:
Ensure the backboard is firmly secured before fitting the cushion or using the wheelchair.
6. Re-fit safety “R” clip.
7. Repeat steps 5 and 6 for opposite side.
4. Adjust backrest to desired angle.
5. Re-fit the handwheels to the available holes in the backrest. Hand tighten only.