Support User Manuals

Invacare Terminator BB Wheelchair User Manual

Open as PDF

of 76

SECTION 6—SEAT

Everyday and Sport Series Wheelchairs 60 Part No 1114851

Adjusting Transformer Seat Height

NOTE:Forthisprocedure,refertoFIGURE 6.3

Adjusting Front Seat Height

1. Notetheorderofthemountingscrew,covedwashers,spacer,halfclampsand

mountingscrew/threadedsleeveandtheirpositiononthewheelchairframeand

footresttubing(DetailʺAʺ,FIGURE 6.3).

2. Removethemountingscrew,covedwashers,spacer,halfclampsandmounting

screw/threadedsleeveonbothsidesofthewheelchair.

NOTE:Thefootresttubingwillslideoncethehardwareisremoved.

3. Raise/lowerthefrontoftheseattothedesiredposition.

4. Adjustthefootrestheightifdesired.RefertoAdjustingtheX‐terminatorand

TransformerFootrestsonpage 65.

5. Alignthefootresttubingadjustmentholeswiththedesiredwheelchairframe

adjustmentholes.

6. Installthe hardwareremovedin STEP2throughtheadjustment holesaligned inSTEP5. 

7. Securelytightenallhardware.

Adjusting Rear Seat Height

1. Loosenthetwomountingscrewsonbothsidesofthefrontofthewheelchair(Detail

ʺAʺ).

2. Loosenthefouradjustmentscrewsonbothsidesoftherearofthewheelchair(Detail

ʺBʺ).

3. Adjustseathigherorlowertodesiredposition.Useatapemeasureorrulertoensure

thatbothsidesarethesameheight.

4. Securelytightenthefouradjustmentscrewsattherearofthewheelchairandthetwo

mountingscrewsatthefrontofthewheelchair.

previous next