Support User Manuals

Invacare Terminator BB Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Everyday and Sport Series Wheelchairs 50 Part No 1114851

NOTE:A4CamberSystemOnly‐Makesurethenotchesintheaxletubearetowardstherearof

thewheelchairandtheslotsintheaxletubearefacingup.

10. A4CamberSystemOnly‐Installtheadjustmentringsontothenewaxletube.Make

surethestopsontheadjustmentringsarefacingtowardstheoutsideofthe

wheelchair.

NOTE:DONOTtightenthephillipsscrewsthatsecuretheadjustmentringstotheaxletubeat

thistime.

11. Slidethenewaxletubethroughtheothercamberclampuntiltheaxletubeisevenly

spacedbetweenthecamberclamps.

NOTE:DONOTclosethecamberclampsatthistime.

ƽ WARNING

NEVER position the camber inserts in the axle tube with more than 3 inches (12

indexing marks showing) of the camber insert outside of the axle tube. The camber

inserts will not be securely tightened in the axle tube. Possible injury to the user or

damage to the wheelchair may occur.

12. A4CamberSystemOnly‐InstallcamberinsertsintotheNEWaxletubeandslidethe

camberinsertstothepositionnotedinSTEP1.Makesuretherearenomorethan3

inches(12indexingmarks)ofthecamberinsertsoutsideoftheaxletube.

13. A4CamberSystemOnly‐Slidetheindexingringonthecamberinsertuntilitisflush

withthecamberclamp.

NOTE:Tomaximizerollability:Beforeusingthewheelchair,makesur ebothcamberinsertsareset

tothesameindexingnotch.Thiswillmakesurethedistancebetweentherearwheelandthe

wheelchairisthesameonbothsides.

14. Installtherearwheelsontothewheelchair.RefertoRemoving/InstallingRearWheels

onpage 35.

15. Adjusttheaxletube.RefertoAdjustingtheAxleTube

onpage 51.

NOTE:Theperformanceofthewheelchairwillbeaffectedifthetoein/toeoutofthewheelchairis

notcorrect.RefertoDeterminingToeIn/ToeOut

onpage 42.

previous next