Support User Manuals

Invacare R51LXP Mobility Aid User Manual

Open as PDF

of 76

SECTION 6—FRONT RIGGINGS

Part No.1106645 36 Nutron® Series

4. Performone(1)ofthefollowing:

•Adjusting:

NOTE:Telescopingfrontriggingsupportsmaybeextendedupto2‐inchesfromthewheelchair

framein1‐inchincrements.Thisadjustmentdoesnoteffectseatdepth.

i. Positionthetelescopingfrontriggingsupporttothedesireddepth.

•Replacing:

i. Removetheexistingtelescopingfrontriggingsupportfromthewheelchair

frame.

ii. Insertthenewtelescopingfrontriggingsupportintothewheelchairframe.

iii. Positionthetelescopingfrontriggingsupporttothedesireddepth.

NOTE:Thefootplatewillbeontheinsideofthewheelchairwhenlockedinplace.

5. Usingthefrontandrearsocketboltsandtwo(2)locknuts,securethetelescoping

front

riggingsupporttothewheelchairframeasshowninFIGURE 6.7.

6. Usingthelongsocketboltandlocknut,securetheH‐blockandspacertothe

wheelchairframeandthetelescopingfrontriggingsupportasshowninFIGURE 6.7.

7. SnapcrossbracesintoH‐blocks.Wigglecrossbracestomakesuretheyaresecuredin



theH‐blocks.

8. Ifnecessary,repeatSTEPS1‐8onremainingtelescopingfrontriggingsupport.

FIGURE 6.7 Adjusting/Replacing Telescoping Front Rigging Support

Wheelchair Frame

Rear Socket Bolt

Long Socket Bolt

Front Socket Bolt

Spacer

H-Block

Locknuts

Do Not Use With

Front Socket Bolt

Telescoping Front

Rigging Support

2-inch

0-inch

1-inch

Front Socket Bolt Positions

(Depth)

previous next