Filter
Top Products
25
CALF-PAD BRACKETS IN FORWARD MOUNT
POSITION
5/16-24 x 3-inch
Mounting Screws
Calf-Pad
Bracket
Calf-Pad
Bracket
Washer
Washer
Locknuts
FIGURE 22 - ADJUSTING THE CALF-PAD DEPTH - DIRECT MOUNT METHOD
SIDE VIEW
Legrest
Tube
Calf-Pad
SIDE VIEW
Legrest
Tube
Calf-Pad
CALF PAD-BRACKETS IN REVERSE MOUNT POSITION
Legrest
Tube
Locknuts
Small
Washers
Large Washer
Mounting Bolt
Center
Mounting
Screw
Hub Cap
Calf-Pad Bracket
Mounting Screw
Nylon Spacer
Large Washer
Caplug Washer
Locknut
Hub Cap
Caplug Washer
Calf-Pad
Bracket
Pivot
Bracket
ADJUSTING THE CALF-PAD DEPTH USING
THE DIRECT MOUNT METHOD (FIGURE 22).
1. Remove the calf-pads. Refer to
REMOVING/INSTALL-
ING THE CALF PADS in this procedure of the manual.
2. Remove the center mounting screw, nylon spacer,
small washer, and locknut that secure the calf-pad
bracket to the pivot bracket.
3. Remove the other mounting screw and locknut that
secure the calf-pad bracket to the pivot bracket.
4. Perform STEPS 1-3 for other calf-pad mounting
bracket.
5. Remove the two (2) hub caps from the pivot
bracket.
6. Remove the mounting bolt, two (2) caplug wash-
ers, two (2) large washers and locknut that se-
cure the pivot bracket to the legrest tube.
NOTE: Save the pivot bracket and attaching mount-
ing hardware from STEPS 2-6 for future use. Securely
tighten.
7. Position the calf-pad brackets on the legrest tube
in the desired orientation. Refer to FIGURE 22.
8. Secure the calf-pad brackets to the legrest tube with
the two (2) 5/16-24 x 3-inch long mounting screws,
washers and locknuts in the orientation determined
in STEP 7.
9. Install the calf-pads. Refer to
REMOVING/INSTALL-
ING THE CALF PADS in this procedure of the manual.
F
R
O
N
T
R
I
G
G
I
N
G
S
FRONT RIGGINGS PROCEDURE 3