Support User Manuals

Invacare L-3X Mobility Aid User Manual

Open as PDF

of 48

SECTION 9—WHEELS AND CASTERS

Lynx™L-3X 32 Part No. 1145807

SECTION 9—WHEELS AND CASTERS

ƽ WARNING

After any adjustments, repair or service and before use, make sure that all attaching

hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service, turn power Off and

remove key from ignition.

Removing/Installing the Drive Wheels

NOTE:Forthisprocedure,refertoFIGURE 9.1onpage 33.

Removing

1. Turnpoweroffandremovethekeyfromtheignition.

2. Removetheseat.RefertoRemoving/InstallingtheSeatonpage 27.

3. Placetherearframeassembly(notshown)uponblockssothatthedrivewheelsare

offtheground.

4. Removethecap,nut,largewasherandsmallwasherthatsecurethedrivewheeltothe

driveshaft.

5. Removetheexistingdrivewheelassemblyfromthedriveshaft.

NOTE:Useawheelpullerifnecessarytoremovethewheelfromthedriveshaft.

6. Removekeystockfromdriveshaft.Setaside.

7. Ifnecessary,repeatSTEPS1‐6toremoveotherdrivewheel.

Installing

1. PlacekeystockincutoutondriveshaftasshowninFIGURE 9.1.

NOTE:ThekeystockinthedriveshaftMUSTlineupwiththecutoutinthewheelhub.

NOTE:Ifnecessary,usearubberhammertogentlytapdrivewheelcompletelyintopositiononthe

driveshaft.

2. Installthedrivewheelontothe

driveshaft.

3. Securewheeltodriveshaftusingthelargewasher,smallwasherandnut.Securely

tighten.

4. Installthecapontothenut.

5. RepeatSTEPS1‐4toinstalltheotherdrivewheel.

6. Installtheseat.RefertoRemoving/InstallingtheSeatonpage 27.

previous next