Filter
Top Products
Part No. 1110545 73 A4
FIGURE 2 - REPLACING FRONT ELASTOMERS
Mounting
Screw (Use
Loctite 242)
Elastomer
Upper Portion
of Fork
Lower Portion of Fork
Mounting Screw
REPLACING FRONT ELASTOMERS (FIGURE 2)
CAUTION
DO NOT use excessive force when removing/installing the threaded
sleeve from/onto the fork. Damage to the threaded sleeve may occur.
1. Using two (2) allen wrenches, turn mounting screws in opposite directions and
remove one (1) mounting screw from fork.
NOTE: One (1) mounting screw will not turn.
2. Remove the threaded sleeve and mounting screw assembly from the fork. DO NOT
use excessive force.
3. Remove the EXISTING elastomer from the fork.
4. Install NEW elastomer into fork.
NOTE: Make sure the elastomer sits in the two (2) recessed areas on the fork.
5. Align the mounting holes in the upper and lower portion of the fork.
6. Reinstall threaded sleeve and mounting screw assembly. DO NOT use excessive force.
WARNING
Use Loctite 242 when reinstalling the mounting screw into the threaded
sleeve, otherwise the fork can become disassembled. Possible injury or
damage could result.
7. Apply Loctite 242 to the mounting screw.
8. Reinstall the mounting screw into the threaded sleeve and tighten securely.
Threaded
Sleeve
SUSPENSION SECTION 9
SUSPENSION