Filter
Top Products
Part No. 1110545 37 A4
FRAME
REPOSITIONING CAMBER INSERTS (ADJUSTING REAR
WHEEL CAMBER) (FIGURE 9)
NOTE: Perform this procedure on one (1) side of the wheelchair at a time for ease of adjustment.
1. Open the camber clamp. Refer to OPENING/CLOSING CAMBER clamps in this
section of the manual.
2. Pull one (1) rear wheel with the camber insert out of the axle tube.
3. Remove the rear wheel from the camber insert. Refer to REMOVING/INSTALLING
REAR WHEELS in SECTION 5 of the manual.
4. Rotate the camber insert 180°.
5. Reinstall the rear wheel into the camber insert. Refer to
REMOVING/INSTALLING
REAR WHEELS in SECTION 5 of the manual.
WARNING
NEVER position the camber inserts in the axle tube with more than 3-
inches (12 indexing marks showing) of the camber insert outside of the
axle tube. Otherwise, the camber inserts will not be securely tightened in
the axle tube resulting in possible injury to the user or damage to the
wheelchair.
6. Position camber insert to desired position. Make sure there are no more than 3-
inches (12 indexing marks) of the camber inserts outside of axle tube.
7. Slide the indexing ring on the camber insert until it is flush with the camber clamp.
WARNING
QUICK-RELEASE LEVERS - Make sure the quick-release levers are in the
CLOSED position BEFORE using the wheelchair, otherwise personal injury
or damage to the wheelchair may occur.
STANDARD AND SUSPENSION CAMBER CLAMPS - Make sure the hex
screws are securely tightened BEFORE using the wheelchair, otherwise
personal injury or damage to the wheelchair may occur.
CAUTION
DO NOT close the quick-release levers or tighten the socket screws or hex screws
without camber inserts in the axle tube. Damage to the axle tube will occur.
8. Close the camber clamp. Refer to OPENING/CLOSING CAMBER clamps in this
section of the manual.
9. Repeat STEPS 1-8 for opposite side of wheelchair.
NOTE: Before using the wheelchair, make sure both camber inserts are set to the same indexing
mark. This will make sure the distance between the rear wheel and the wheelchair is the same on
both sides.
10. Wheelchairs equipped with 0°/9°, 0°/12°, 3°/9°, 6°/9°
, 3°/12° or 6°/12°
camber inserts - Adjust the toe in/toe out of the wheelchair. Refer to
ADJUSTING TOE IN/TOE OUT in this section of the manual.
SECTION 4 FRAME
FRAME