Filter
Top Products
A4 30 Part No. 1110545
GENERAL GUIDELINES
OPENING/CLOSING CAMBER CLAMPS (FIGURE 5)
WARNING
QUICK-RELEASE LEVERS - Make sure the quick-release levers are in the
CLOSED position BEFORE using the wheelchair, otherwise personal injury
or damage to the wheelchair may occur.
STANDARD AND SUSPENSION CAMBER CLAMPS - Make sure the hex
screws are securely tightened BEFORE using the wheelchair, otherwise
personal injury or damage to the wheelchair may occur.
CAUTION
DO NOT close the quick-release levers or tighten the socket screws or hex
screws without camber inserts in the axle tube. Damage to the axle tube
will occur.
1. Perform one (1) of the following to open a camber clamp:
A. QUICK-RELEASE LEVERS - Pull the quick-release lever to the open position.
B. STANDARD CAMBER CLAMPS - Loosen, but do not remove the socket
screw on the camber clamp.
C. SUSPENSION CAMBER CLAMPS - Loosen, but do not remove the hex
screw on the bottom rear of the camber clamp.
2. Perform one (1) of the following to close a camber clamp:
A. QUICK-RELEASE LEVERS - Secure the quick-release lever to the camber
clamp by threading it completely into the camber clamp. Push the quick-release
lever on the camber clamps to the closed position.
B. STANDARD CAMBER CLAMPS - Securely tighten the socket screw to
secure the axle tube.
C. SUSPENSION CAMBER CLAMPS - Securely tighten the hex screw on the
bottom rear of the camber clamp to secure the axle tube.
SECTION 4 FRAME
FRAME