Filter
Top Products
Part No. 1110545 61 A4
ANTI-TIPPER ADJUSTMENT/REPLACEMENT (FIGURE 1)
WARNING
Anti-tippers MUST BE attached at all times. Inasmuch as the
ANTI-TIPPERS are an option on this wheelchair (You may order it with
or without the anti-tippers), Invacare strongly recommends ordering the
anti-tippers as an additional safeguard for the wheelchair user.
Anti-tippers MUST be fully engaged. Ensure the the release button of the
anti-tipper fully protrudes out of the hole in the anti-tipper socket.
Ensure both anti-tippers are adjusted to the same height.
NOTE: To ensure the correct model anti-tipper is used refer to FIGURE 1. Measurements for anti-
tippers are approximate and are taken using the TOP adjustment hole on the anti-tipper (DETAIL "A").
ANTI-TIPPER ADJUSTMENT
WARNING
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a
1-1/2 to 2-inch clearance between the bottom of the anti-tipper wheels
and the ground/floor. This spacing should always be checked whenever
adjustments/changes are made to the wheelchair. Failure to maintain
proper spacing may result in the chair tipping over backward causing
serious injury or property damage.
1. Press in the release button that secures the anti-tipper wheels to the anti-tipper bar.
2. Adjust the height of the anti-tipper wheels to between 1-1/2 and 2-inches of the
ground/floor.
3. Repeat STEPS 1-2 for the opposite anti-tipper.
Section 7 - Anti-tippers includes the following:
Anti-tipper Adjustment/Replacement
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all
attachment hardware is tightened securely - otherwise, injury or damage
may result.
ANTI-TIPPERS SECTION 7
ANTI-TIPPERS