Filter
Top Products
Part No. 1110545 47 A4
HANDRIM REPLACEMENT (FIGURE 6)
1. Remove rear wheel from the wheelchair.
WARNING
Tire MUST be deflated before any disassembly procedures are
performed.
2. Remove all air from the tire by pressing down on the pin in the center of the valve
stem.
3. While carefully holding the tire, bar and rim strip to one side, hold the phillips
screws and remove the locknuts that secure the handrim to the rear wheel.
4. Remove the existing handrim.
5. Install the new handrim by reversing the above procedures.
WARNING
DO NOT inflate tire until it is completely assembled.
6. Inflate tire to correct psi rating on the sidewall of tire.
WARNING
Make sure detent pin is fully released BEFORE operating the wheelchair.
7. Reinstall rear wheel to the wheelchair.
8. Repeat the procedure for the opposite rear wheel if necessary.
Phillips
Screw
Locknut
Handrim
FIGURE 6 - HANDRIM REPLACEMENT
REPAIRING/REPLACING REAR WHEEL TIRE/TUBE
WARNING
Replacement of a pneumatic tire or tube MUST be performed by a
qualified technician.
SECTION 5
WHEELS
WHEELS