Filter
Top Products
36
Hex Bolts
Locknuts
Washers
Wheelchair
Frame
3-inch
Seat
Cushion
Position
2-inch
Seat
Cushion
Position
Recliner Brackets
FIGURE 19 - REPOSITIONING BACK FOR
2 OR 3-INCH SEAT CUSHION - RECLINERS ONLY
REPLACING FOLDING PUSH HANDLE -
RECLINERS ONLY (FIGURE 20)
NOTE: Refer to the SAFETY/HANDLING section
of this manual to fold and unfold the wheelchair.
1. Remove the phillips bolts and locknuts that secure
the existing folding push handle and trigger release
levers to the back cane.
2. Remove the existing folding push handle from the
back canes.
3. Install the new folding push handle into the back
canes.
4. Line up the mounting holes in the new folding push
handle with the mounting holes in the back canes.
5. Reinstall the phillips bolts through the trigger release
levers, back canes and the new folding push handle
and tighten securely with the locknuts.
INSTALLING AND REMOVING A SEATING
SYSTEM
If a seating system is being used on the wheel-
chair, refer to the seating system Owner's
Manual for installation and removal.
Trigger Release
Lever
Locknut
Back Cane
Phillips Bolt
FIGURE 20 - REPLACING FOLDING PUSH
HANDLE - RECLINERS ONLY
Folding Push Handle
PROCEDURE 3 BACK
B
A
C
K
4. Position the recliner brackets on the wheelchair frame
at the position determined in STEP 3.
5. Reinstall the hex bolts, washers and locknuts through
the recliner brackets and wheelchair frame and tighten
securely. Refer to FIGURE 19 for correct hardware
orientation.
6. Reinstall the rear wheels onto the wheelchair. Refer
to REMOVING/INSTALLING REAR WHEELS in
PROCEDURE 6 of this manual.