Filter
Top Products
17
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. After seated in wheelchair, adjust footrest to cor-
rect height by loosening nut and sliding the pivot
tube up or down until desired height is obtained.
6. To release the legrest, push the legrest release
handle toward the inside of the wheelchair and
swing the legrest to the outside of the wheelchair.
INSTALLING 3-INCH EXTENSION (FIGURE 4)
NOTE: Make sure to note position of hardware
before disassembly of the footrest.
NOTE: If using ANY type of extension with the
ADJUSTABLE ANGLE FOOTPLATE, refer to
INSTALLING/ADJUSTING ADJUSTABLE ANGLE
FLIP-UP FOOTPLATES in this section of the
manual.
1. Remove any accessories that are attached to the
footrests.
2. Remove the socket bolt, coved washer and lock-
nut that secure the footplate to the footrest sup-
port.
3. Insert the 3-inch extension into the footrest sup-
port and align the mounting holes.
4. Secure the 3-inch extension to the footrest sup-
port with new hex bolt, washer and locknut.
5. Position the footplate at the desired height.
WARNING
DO NOT overtighten. Footrest must be able to
rotate upward from the horizontal to vertical po-
sition.
6. Reinstall the socket bolt through the mounting
holes of the footplate and footrest support.
7. Secure the footplate to the footrest support with
the coved washer and locknut.
INSTALLING ELEVATING LEGRESTS
(FIGURE 5)
1. Insert the pivot tube into the legrest support and
secure it with the bolt and nut.
2. Place legrest on the outside of the wheelchair and
insert the mounting pin into the mounting tube.
3. Rotate legrest toward the inside of the wheelchair
until it locks in place.
FRONT RIGGINGS PROCEDURE 1
F
R
O
N
T
R
I
G
G
I
N
G
S
FIGURE 4 - INSTALLING 3-INCH EXTENSION
Footrest
Support
Locknut
Washer
Hex Bolt
Socket Bolt,
Coved Washer
and Locknut
3-inch
Extension
FIGURE 5 - INSTALLING ELEVATING LEGRESTS
Bolt and Nut
Pivot Tube
Legrest
Support
Legrest
Release
Handle
Mounting Pin
Mounting
Tube
Footplate
RAISING/LOWERING ELEVATING LEGRESTS
AND/OR ADJUSTING CALFPADS (FIGURE 6)
Raising/Lowering Elevating Legrests
1. Perform one (1) of the following:
RAISING - Pull back on the release lever un-
til the leg is at the desired height.
LOWERING - Support leg with one (1) hand and
push release lever downward with
other hand.
FIGURE 6 - RAISING/LOWERING ELEVATING
LEGRESTS AND/OR ADJUSTING CALFPADS
Calfpad Rotated For
Height Adjustment
Release Lever
Calfpad