Filter
Top Products
26
PROCEDURE 2 ARMS
A
R
M
S
INSTALLING FABRIC CLOTHING GUARDS
(FIGURE 14)
1. Remove the seat cushion, if necessary.
2. Secure the fastening straps of the fabric clothing pro-
tectors to the seat upholstery.
3. Reinstall the seat cushion, if necessary.
4. Remove the two (2) phillips screws that secure the
back upholstery to the back canes.
5. Position the D-rings on the mounting holes in the
back canes.
6. Reinstall the two (2) phillips screws and securely
tighten.
7. Run the nylon cord evenly through the two (2) D-
rings.
8. Run the nylon cord through the cord lock.
9. Push star wheel into cord lock to hold the nylon cord
in place.
10. Tie a knot in the nylon cord and cut the excess, if
desired.
Phillips
Screw,
D-ring
Star
Wheel
Cord Lock
Fabric Clothing
Guard
Fastening Strap
Seat Upholstery
Phillips Screw,
D-ring
Nylon Cord
FIGURE 14 - INSTALLING FABRIC CLOTHING
GUARDS
INSTALLING RIGID SIDE GUARDS (FIGURE 15)
1. Position the unthreaded half clamp on the INSIDE
of the wheelchair frame.
2. Position the threaded half clamp on the OUTSIDE
of the wheelchair frame.
3. Install the washer and socket screw through the two
(2) half clamps and loosely tighten.
4. Slide the rigid side guard into the slot on the threaded
half clamp.
5. Determine the necessary position for the rigid side
guard.
6. Securely tighten the two (2) half clamps together with
the socket screw.
ADJUSTING CONVENTIONAL ARM HEIGHT,
REMOVING OR REPLACING
CONVENTIONAL ARMS (FIGURE 16)
WARNING
Make sure the armrest release levers are secured
before using the wheelchair.
Adjusting Conventional Arm Height
1. Unlock the conventional arm by flipping the arm-
rest release lever on the top front of the armrest
to the UP (HORIZONTAL) position.
2. Adjust conventional arm to desired height.
NOTE: Height adjustment levers MUST be in the
unlocked position when placing upper arm into
the arm assembly.
3. Lock the conventional arm by pressing the release
lever into the DOWN (VERTICAL) position when
the desired armrest height is achieved.
Removing Conventional Arms
1. Unlock the conventional by turning the armrest
release lever located on the side rail to the un-
locked position.
2. Remove the conventional arm from the wheel-
chair.
Replacing Conventional Arms
NOTE: Armrest release levers MUST be in the un-
locked position when placing armrests into the arm
sockets.
1. Position the conventional arm in the arm sockets
and lock the conventional arm by turning the arm-
rest release levers into the locked position.
Socket Screw
Rigid
Side
Guard
Unthreaded Half Clamp
Washer
Threaded Half Clamp
FIGURE 15 - INSTALLING RIGID SIDE GUARDS
Wheelchair Frame