Filter
Top Products
Remote Control 109
Waking up your pump
The remote control will operate within 24 inches from your pump.
When the remote control is in “sleep mode,” the green light will be
off. Your pump seeks a signal from the remote every two to three
seconds.
Continuing to hold the ACT button, after the pump “wakes up,”
may result in the pump returning to sleep mode.
1. Press and hold the ACT button on the remote for approxi-
mately 3 seconds, the green light will blink quickly and a
beep/vibrate will occur when your pump wakes up.
2. Release the ACT button when you hear the beep/vibrate from
the pump.
3. You can now perform an Easy Bolus or Suspend the pump.
When the remote battery is low, the green light will blink in a
series of three quick flashes until the battery is replaced. When
this happens, replace the battery in the remote control as soon as
possible.
The pump will not receive signals from the remote control while
the Low Battery condition exists in the pump. Replacing the cur-
rent pump battery with a new battery will restore remote control
function.