Filter
Top Products
22 GF0600050RevE06, August 2006 Everest with Captain Seat Owner's Manual
COWL
Remove cowl (refer to the picture at right)
1. Remove seat: Follow steps 1-4 in the earlier section, Remove seat.
2. Remove the two locking
pins that secure the rear seat
mounts to the base frame at
the rear of the wheelchair.
3. Remove the two rear seat
mounts.
4. Ensure that drive engage
-
ment levers are engaged, so
that levers will fit through
slots in cowl when cowl is
lifted over them.
Front wheel drive: Drive
engagement levers are
pointing toward the rear of
the wheelchair when en-
gaged.
Rear wheel drive: Drive en-
gagement levers are point-
ing toward the front of the
wheelchair when engaged.
5. Lift cowl up and off base frame. ere are Velcro® strips at front and rear that secure cowl to base
frame; you must pull these loose to remove the cowl. *
* Velcro is a registered trademark of Velcro Industries B.V.
Install cowl (refer to the picture above)
1. Slide the cowl down onto the base frame. Press on the areas at front and rear where the Velcro strips
fasten the cowl to the base frame. Ensure that the cowl is securely fastened to the base frame at these
points.
2. Install the two rear seat mounts. Ensure that both rear seat mounts are installed at the same height.
3. Install the two locking pins that secure the rear seat mounts to the base frame.
cowl installed
(front wheel drive shown)
rear seat
mount
locking pin
drive
engagement
lever