Filter
Top Products
20 GF0600050RevE06, August 2006 Everest with Captain Seat Owner's Manual
SEAT
You must remove the Everest with Captain Seat seat in order to perform certain seat height adjustments.
Note: Removing the seat is best performed with a partner so that you are able to use both hands to re-
move the seat.
Remove seat (refer to the pictures at right)
1. Engage the drive wheels (with the drive engagement levers) and turn wheelchair power off.
2. Find the end of the hand control cable and disconnect the hand control connector from the exten
-
sion cable connector where it emerges from a hole in the cowl.
3. Two locking pins secure the seat
frame to the base frame at the front
of the wheelchair. Remove these two
locking pins.
4. Lift the seat up and off the base,
moving the seat slightly forward to
disengage the seat frame from the
hooks at the back of the base that
secure seat frame to base frame.
Install seat (refer to the pictures
at right)
1. Slide the seat down and onto the
base frame. Engage the rear seat
frame hooks with the rear base
frame hooks; engage the front seat
frame mount tubes with the base
frame front mount tubes. Ensure
that rear seat frame hooks are en-
gaged with rear base frame hooks
before continuing.
2. Install the two locking pins that
secure the seat frame to the base
frame at the front of the wheelchair.
3. Connect the hand control connec-
tor to the extension cable connector
where it emerges from a hole in the
cowl.
WARNING: Ensure that rear seat frame hooks are engaged with rear base frame hooks
and that all four locking pins are locked in place before occupying or oper-
ating wheelchair.
seat installed
locking pin
seat
seat frame
seat removed
seat frame
front mount tube
base frame
front mount tube
base frame
rear mount
tube
rear seat
frame hook
rear base
frame hook