Filter
Top Products
42
Using the AP Manager (continued)
Device Configuration>AP Mode
• Access Point: The default setting used to create a wireless LAN.
• PtP Bridge: Allows you to connect two wireless LANs together. This only works with
another DWL-7100AP. If enabled you must enter the MAC address of the other
DWL-7100AP.
• PtMP Bridge: Allows you to connect mulitple wireless LANs together. All other LANs
must be using DWL-7100APs. When enabled, you must enter the MAC address of
the other DWL-7100APs. Enter up to eight addresses.
• AP Repeater: Allows you to repeat the wireless signal of the root access point. When
enabled you must enter the MAC address of the root access point.
• AP Client: Allows any device with an Ethernet connection to connect to the wireless
network via another DWL-7100AP, such as a printer, gaming console (Xbox, PS2),
or a computer. You will need to enter the SSID of the DWL-7100AP that is functioning
as an AP.
The following featuresare configurable in IEEE802.11a & IEEE802.11g: