Filter
Top Products
Page 33
WHEELCHAIR AND OCCUPANT RESTRAINT
1. Connect chair
hook to a solid
frame member of
the chair close to
the point where
the chair back and
cushion meet (as
shown in Photo J).
2. Position and
connect belt keeper
ÀWWLQJDWWDFKPHQW
to appropriate track
anchorage point
(slots). Attach
keeper as detailed
on page 29. Pull
ÀUPO\RQEHOWWR
HQVXUHÀWWLQJLV
locked in track.
Note: Belt angles
should be as
shown in Figure 2.
J
K
L
M
3. With buckle open,
pull loose end of belt
until tight (see Photo
L). While holding the
loose end with one
hand, close the lever
of the clamp (buckle)
down until it locks.
See Photo M.
4. Connect Velcro
™
tabs to keep excess
EHOWRIIÁRRU6HH
Photo N).
Repeat procedures
for opposite side belt.
Note: Check to see
that front and rear
belts are tight and
the chair is secure
enough that it does
not have any move-
ment. Lock wheel-
chair brakes.
Rear Over-Center
%HOW$WWDFKPHQWV
N
O
%HOW5HOHDVH Press
lever clamp (lock) to
release tension on belt.
Keeper
Hook
Velcro
™
Tabs