Filter
Top Products
Page 17
OPERATION
.QHHO2YHUULGH)HDWXUHV
In the event the Rampvan is in the
kneeled position and you experi-
ence power or equipment failure,
an electrical override and a me-
chanical override are available to
raise the rear of the vehicle. The
vehicle cannot be lowered using
override features.
Use the Electrical Override Switch
if possible (details at right). The
rear of the vehicle can be raised
using the mechanical override
if there is an electrical problem
(manual procedures). See Kneel
Mechanical Override on next page.
Do not drive the Rampvan with the
rear of the vehicle in the lowered
position. Attempting to do so will
result in an extremely rough and
unstable ride.
In the event of a kneel system
failure, have the kneel system
repaired immediately. Contact
your sales representative or
call The Braun Corporation at
1-800-THE LIFT
®
. One of our
national Product Support rep-
resentatives will direct you to
an authorized service center.
.QHHO(OHFWULFDO2YHUULGH
The Kneel Override is avail-
able to electrically power the
kneel system direct (by-pass-
ing the electronic control
system). The Kneel Override
Switch is located on the pas-
senger side C-pillar (rear of
the slide door).
Press and hold the switch to re-
lease the kneel system (raise ve-
hicle). Release the switch when
the rear of the Rampvan has
raised fully. The kneel actuator
motor will ratchet (make clicking
sound).
3UHVVDQGKROG this switch to
release kneel (raise vehicle).
Kneel Override Switch