Filter
Top Products
Page 19
OPERATION
Power Ramp Operation
The power ramp is activated by
the One-Touch electronic control
system. When a control switch is
pressed to start the Open func-
tions, the power door opens. Once
the door reaches the fully open po-
sition, there is a slight delay before
the ramp begins to deploy.
When the Close functions are
activated, the ramp (stows) im-
mediately.
If a control switch is pressed and
released while the ramp is de-
ploying, the ramp motor will stop
running. Press a switch again and
the ramp will stow and the door will
close.
Once the Open sequence of func-
tions is complete (door is fully open
and ramp is deployed), press and
release a control switch to stow the
ramp. If a control switch is pressed
while the ramp is stowing, the ramp
will reverse direction (deploy fully
and stop). Press a control switch
again and the ramp will stow and
the door will close.
Note: If the center console Kneel
On/Off switch is in the ON position,
the rear of the vehicle will descend
as the ramp is deploying. Inversely,
the vehicle will raise when the ramp
is stowing.
Manual operation of the passen-
ger slide door handles will disable
ramp deployment. To enable ramp
deployment, close the passenger
slide door using the keyless entry
transmitter, any interior mounted
switch or the magnetic entry (if
equipped).
CAUTION
$OORZUDPSWRGHSOR\
IXOO\EHIRUHERDUGLQJ
)DLOXUHWRGRVRPD\
UHVXOWLQGDPDJH
If the power ramp is obstructed
while deploying, the ramp will
reverse direction and stow fully
SURYLGHGWKHUDPSPHHWVVXIÀ-
cient resistance).
Allow the power ramp to deploy
(unfold and lower) fully before
boarding the ramp. Forcing the
ramp out or down during the
deploy/stow functions, or board-
ing onto the ramp before it is fully
deployed PD\UHVXOWLQGDPDJH
to the ramp, the electronic control-
ler and/or motor assembly.