Braun 32899 Rev A Mobility Aid User Manual


 
Page 28
WHEELCHAIR AND OCCUPANT RESTRAINT
5HVWUDLQW%HOW$QJOHV
Locate wheelchair in forward-facing position center-
ing wheelchair squarely within “L” track. The front
and rear belts, when attached, should create angles
approximately as shown in Figure 2. Preferred
angles and locations of belts from wheelchair se-
curement points to vehicle anchor points are shown.
Front tie-downs should be angled out far for lateral
stability when possible. Note: These are optimum
angles and cannot be achieved in some cases.
.HHSHU)LWWLQJDQG´/µ7UDFN$WWDFKPHQW
Instructions
The belts supplied in the Forward-Facing Wheelchair
and Occupant Belt/Track System are equipped with
NHHSHUÀWWLQJVDWWDFKPHQWVZKLFKHQJDJHWKH´/µ
WUDFN(QJDJHDQGUHOHDVHWKHNHHSHUÀWWLQJVDVGH-
tailed and shown on page 29. Note: Lift to remove
the “L” track plastic covers. Refer to pages 30-34 for
belt attachment and release procedures.
Figure 2
Front View
:KHHOFKDLU5HIHUHQFH3ODQH
Rear
Securement
Points
Front
Securement
Points
12"
12"
45°
Side View
Side ViewRear View
30°
10°10°
40°
60°
25° 25°