Bil-Jax XLB-4319 Personal Lift User Manual


 
XLB-4319
5-2
B06-00-0363B
B06-00-0406
XLB-4319
FTC B06-00-0409
EMERGENCY
ROTATION GEAR
B06-00-0409
LUBRICATE
WEEKLY
COIA B06-00-0036
B06-00-0036
LUBRICATE
MONTHLY
B06-00-0130
RIF
B06-00-0130
450 LBS.
MAXIMUM CAPACITY
CCTT B06-00-0380
B06-00-0380
LUBRICATE
SEMI-ANNUALLY
COIA B06-00-0037
B06-00-0037
MANUAL PUMP HANDLE
COIA B06-00-0043
B06-00-0043
THIS PLUG 115 VOLT
RIL
B06-00-0062
B06-00-0062
B06-00-0405
EMERGENCY ROTATION HANDLE
OFA B06-00-0268
B06-00-0268
COIA/RFT B06-00-0033
THIS UNIT SHALL ONLY BE TOWED
WHEN ALL BOOM SECTIONS ARE FULLY
DOWN AND LOCKED WITH TRANSPORT
SAFETY PINS.
CAUTION
B06-00-0033
SAFETY
HARNESS
LANYARD
ATTACHMENT
POINT
B06-00-0173UFC
B06-00-0173
This machine is NOT insulated. Do not use within 10 ft. of power
lines or other electrically charged sources. This machine
DOES
NOT provide protection for personnel from contact with or close
proximity to any live electrical power source and
should be consid-
ered energized by all personnel coming in contact with machine.
IT IS UNLAWFUL TO OPERATE
THIS EQUIPMENT WITHIN 10
FEET OF HIGH VOLTAGE
LINES OF 50,000 VOLTS OR
LESS.
For safe clearance of lines in excess of 50,000 volts, see owners manual.
DANGER
FFL
B06-00-0334
B06-00-0334
COFC B06-00-0192
OPERATION AND SERVICE
MANUAL INSIDE
B06-00-0192
LFC B06-00-0189
WARNING
Level machine before use.
Failure to level this machine could
result in serious injury or death!
B06-00-0189
110 VOLT
DANGER
GFT/LFC B06-00-0151
B06-00-0151
This machine is designed and manufactured in compli-
ance with the ANSI A92.2 standard in force on the date of
manufacture. Dealers, owners, users, operators, lessors,
and lessees are responsible for inspection, maintenance,
training, and operation as required by A92.2 and the owners
manual.
Alterations, modifications, or changes to this machine
without the written authorization of Workforce Products,
Inc. as well as any unauthorized adjustment of valves,
disabling or by-passing of safety devices or the improper
use of this machine shall exempt Workforce Products, Inc.
from any liability for any resulting injuries or damage.
FFU
CAUTION
B06-00-0261
B06-00-0261
DANGER
Risk of Electric Shock
DO NOT expose charger to rain, power wash detergents or
spray - DO NOT use frayed or damaged electric cords when
charging.
During charging, explosive oxyhydrogen gas is generated.
DO NOT smoke or allow open fire, sparks, or embers near
battery when charging.
Connect input cord only to properly grounded three wire
outlet with specified voltage and frequency.
Always wear safety goggles and face shield when working
on or near battery.
Check battery acid level at the start of each day. If acid does
not cover the plates, add only enough distilled or demineral-
ized water to completely cover the plates.
Keep terminals and terminal connections clean.
Consult Operation and Maintenance Manual for additional
information on battery maintenance.
FAILURE TO COMPLY WITH THE FOLLOWING INSTRUCTIONS
OR ANY OTHER IMPROPER USE OR MAINTENANCE OF THIS
EQUIPMENT WILL RESULT IN INJURY OR DEATH.
RIR/OFG
B06-00-0034
B06-00-0034
STAY CLEAR
WHILE RAISING
OR LOWERING
WARNING
CCFO
B06-00-0225
B06-00-0225
B06-00-0161B
WARNING
ST
A
Y CLEAR
FTC B06-00-0405
PINCH POINT
© Bil-Jax, Inc. 2004
Figure 5-1. Replacement Decals, Sheet 1 of 3