Filter
Top Products
XLB-4319
1-2
1-2 BEFORE OPERATION
Ensure the following general safety precautions are followed before operating the
XLB-4319 Hydraulic Boom Lift.
• ALWAYS survey the usage area for potential hazards such as untamped earth
fills, unlevel surfaces, overhead obstructions, and electrically charged conduc-
tors or wires. Be aware of any potential hazards and always consider what could
happen. Watch for moving vehicles in the operating area.
• ALWAYS read, understand, and follow the procedures in this manual before at-
tempting to operate equipment.
• ALWAYS inspect the equipment for damaged or worn parts. Check for cracked
welds, hydraulic leaks, damaged wiring, loose wire connectors, damaged out-
riggers, low tire pressure, uneven tire wear, or tire damage. Also check for any
improper operation. NEVER operate equipment if damaged in any way. Im-
properly operating equipment must be repaired before using.
• ALWAYS wear proper clothing for the job. Wear protective equipment as re-
quired by federal, state, or local regulations. The operator MUST wear a safety
harness and lanyard.
• ALWAYS locate, read, and follow all directions and warnings displayed on the
equipment.
• ALWAYS inspect the equipment for “DO NOT USE” tags. NEVER use equip-
ment tagged in this way until all repairs are made and all “DO NOT USE” tags
are removed by authorized maintenance personnel.
• ALWAYS make sure the basket and outrigger shoes are free of mud, grease, or
other slippery material to reduce the possibility of slipping.
• NEVER allow improperly trained personnel to operate this equipment. Only
trained and authorized personnel shall be allowed to operate this equipment.
• NEVER operate this equipment if you are under the influence of alcohol or
drugs, or if you feel ill, dizzy, or unsteady in any way. Operators must be physi-
cally fit, thoroughly trained, and not easily excitable.
• NEVER modify, alter, or change the equipment in any way that would affect its
original design or operation in any way.
• NEVER operate this equipment in ways for which it is not intended.