Filter
Top Products
XLB-4319
4-33
MATERIAL SAFETY DATA SHEET
FOR AW–46 HYDRAULIC OIL
1-SITE SPECIFIC INFORMATION: AW-46 HYDRAULIC OIL
2-GENERAL INFORMATION TRADE NAME: AW-46 HYDRAULIC OIL
EMERGENCY TELEPHONE NUMBERS: (517) 849-2144
CHEMICAL FAMILY: LUBRICATING OIL
CAS NUMBER: MIXTURE: ISSUE DATE 12/15/96
HAZARDOUS INGREDIENTS:
----------------------------------------------------------------------------
CONTAINS NO INGREDIENTS NOW KNOWN TO BE HAZARDOUS AS DEFINED IN OSHA 29 CFR
1910.1000 AND OSHA 29 CFR 1910.1200.
----------------------------------------------------------------------------
HEALTH HAZARD DATA THRESHHOLD LIMIT VALUE: 5mg/m3 AS OIL MIST 8 hr, TWA
PRIMARY ROUTES OF ENTRY: INHALATION, SKIN ABRASION AND INGESTION.
CARCINOGENIC: NO
SYMPTOMS IF INGESTED, CONTACTED WITH SKIN, OR VAPOR INHALED: NO ADVERSE
EFFECTS EXPECTED.
EYES: FLUSH WITH WATER FOR 15 MINUTES SKIN: WASH THOROUGHLY WITH WARM
SOAPY WATER.
INGESTION: DO NOT INDUCE VOMITTING-SEEK MEDICAL ATTENTION.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: NONE KNOWN
AIR EXPOSURE LIMITS: P.E.L. NOT ESTABLISHED T.L.V. 5mg/m3 OSHA 29 CFR
1910.1000
HEALTH: 1 FIRE: 1 SPECIFIC: X REACTIVITY: 0
----------------------------------------------------------------------------
PHYSICAL DATA: BOILING POINT: 400+ DEG F. VAPOR PRESSURE (PSIA): N/A
SPECIFIC GRAVITY (H20=1): 0.87 SOULUBILITY IN WATER: NEGLIGIBLE
PH OF CONCENTRATE: N/A
APPEARANCE AND ODOR: PALE YELLOW, PETROLEUM ODOR
----------------------------------------------------------------------------
FIRE AND EXPLOSION HAZARD DATA FLASH POINT(METHOD USED): 425 DEG F.
FLAMMABLE LIMITS: NOT DETERMINED LEL: N/A UEL: N/A
EXTINGUISHING MEDIA: SAND, DRY CHEMICAL, FOAM, CO2. TREAT AS CLASS B FIRE.
UNUSUAL FIRE AND EXPLOSION HAZARDS: NONE
----------------------------------------------------------------------------
REACTIVIYY DATA STABILITY: STABLE CONDITIONS TO AVOID: AVOID EXTREMES
OF HEAT.
INCOMPATIBILITY (MATERIALS TO AVOID): STRONG OXIDIZING MATERIALS.
HAZARDOUS DECOMPOSITION PRODUCTS: INCOMPLETE COMBUSTION MAY CAUSE CARBON
OXIDES.
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR.
----------------------------------------------------------------------------
SPILL OR LEAK PROCEDURES: STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR
SPILLED. DIKE AND ABSORB ON INERT MATERIAL. FOLLOW ALL LOCAL, STATE, AND
FEDERAL REGULATIONS FOR DISPOSAL OF COLLECTED MATERIAL.
----------------------------------------------------------------------------