ENGLISH
3737
Basic Recording
Searching quickly for a desired scene (Setting the
ZERO MEMORY)
( ZERO
MEMORY)
✤ The ZERO MEMORY function works in both <Camera> and
<Player> modes. ➥page 19
✤ You can mark a point on a tape that you want to return to following
playback.
1. Set the [Power] switch to [CAMERA] or [PLAYER].
2. Set the [Mode] switch to [TAPE].
3. Press the [ZERO MEMORY] button on the remote
control before the recording or during playback at the
point where you wish to return.
■
The time code is changed to a tape counter that
is set to ZERO MEMORY with the < 0:00:00>
(ZERO MEMORY indicator).
■
If you want to cancel the ZERO MEMORY
function, press the [ZERO MEMORY] button
again.
4. Finding the zero position.
■
When you have finished playback, fast forward or
rewind the tape in stop mode.
The tape stops automatically when it reaches the
zero position.
■
When you have finished recording, set the
[Power] switch to [PLAYER] and press
the [
œœœœ
(REW)] button.
The tape stops automatically when it reaches the
zero position.
5. The tape counter with the <>(ZERO MEMORY indicator)
disappears from the display and the tape counter is changed to the
time code.
[ Notes ]
■
In the following situations, ZERO MEMORY mode may be cancelled
automatically:
- At the end of the section marked with the ZERO MEMORY function.
- When the tape is ejected.
- When you remove the Battery Pack or power supply.
■
The ZERO MEMORY may not function correctly where there is a
break between recordings on the tape.
✤
<Camera> (
)
<Player> (
)
➥
19
✤
1. [Power] [CAMERA]
[PLAYER]
2. [Mode] [TAPE]
3.
[ZERO MEMORY]
■
< 0:00:00>
■
[ZERO MEMORY]
4.
■
■
[Power]
[PLAYER] [
œœœœ
(REW)]
5.
■
■
œ
