ENGLISH
2828
Initial Setting : System Menu Setting
✤ The Demonstration function may only be used in the
<Camera> mode without a tape inserted in the
Camcorder. ➥page 19
✤ Before you begin: Make Sure that there is no tape
inserted in the Camcorder. ➥page 32
✤ Demonstration automatically shows you the major
functions that are included with your Camcorder so
that you may use them more easily.
✤ The Demonstration operates repeatedly until the
Demonstration mode switched Off.
1. Set the [Power] switch to [CAMERA].
2. Set the [Mode] switch to [TAPE].
3. Press the [MENU] button.
■
The menu list will appear.
4. Move the [Zoom] lever up or down to select
<System>, then press the [OK] button.
5. Move the [Zoom] lever up or down to select
<Demonstration>, then press the [OK] button.
6. Move the [Zoom] lever up or down to select
<On>, then press the [OK] button.
7. Press the [MENU] button.
■
The Demonstration will begin.
8. To quit the Demonstration, press the [MENU] button.
[ Notes ]
■
The Demonstration function is automatically activated
when the Camcorder is left idle for more than
10 minutes after switching to the <Camera>
mode (no tape is inserted in the Camcorder).
■
If you press other buttons (FADE, MF/AF, PHOTO,
EASY.Q) during the Demonstration mode, the
demonstration stops temporarily and resumes 10
minutes later if you do not operate any other
functions.
✤
<Camera> (
➥
19
✤
➥
32
✤
✤
1. [Power] [CAMERA]
2. [Mode] [TAPE]
3. [MENU]
■
4. [Zoom] <System> (
), [OK]
5. [Zoom]
<Demonstration> ( ), [OK]
6. [Zoom] <On> ( ),
[OK]
7. [MENU]
■
8. [MENU]
■
<Camera> ( )
10
■
(FADE, MF/AF,
PHOTO, EASY.Q) (
, MF/AF, ,
)
10
Viewing the Demonstration (Demonstration)
( )
Move Select Exit
MENUOKZOOM
Off
On
Camera Mode
√System
Clock Set
Remote
Beep Sound
Language
Demonstration
√On
√On
√English
√On
Move Select Exit
MENUOKZOOM
