replacing printer consumables
Operator’s Guide 31
Developer Unit
caution
When
replacing the developer unit, you
must
fill the unit using the starter toner
.
The starter toner bottle contains
magnetic carrier and toner
.
Refer to the adjacent figure and perform
these steps:
1 Unlock the old developer unit by
pushing up on the two green
lock–down clamps.
2
Slide the developer unit out along
the plastic rails on either side of the
printer and pull it out of the printer
.
3 Remove the new developer unit
from the foil package.
4 Hold the new developer unit with
the roller facing into the printer and
slide the unit along the plastic rails
on either side of the printer.
5 Lock the developer unit in place by
pushing the two green lock–down
clamps down until they click into
place.
6 Move the developer unit to verify
that it is locked.
Developer
Unit
Roller (not shown)
Green Clamp
